Used rebuilt 25SS Gear Case. We have rebuilt a single hole water inlet gear case using a Mark 20H length driveshaft.  The gears look like they are new but they are not and the same for the propshaft.  Installed all new bearings and seals, new cone nut, bearing carrier, driveshaft pilot bushing, water pump cartridge and impeller.  Included are new tab washers and mounting nuts.  The case has some wear marks but there are  no cracks or welds.  The vent screw had to be rethreaded to a Number 12/24 screw size.  It turns over smoothly and due to the new impeller being a repro one it is a little taller and causes some resistance.  We will ship the gear foot with out lubrication but we can install Lubriplate 105 if you wish.  Shipping will be added to the cost.